STATESMAN XR510W, Инструкция по эксплуатации, Страница: 7 / 20

7
Removing Transit Bolts
• Loosen the four transit bolts by turning in an anti-clockwise
direction using a spanner.
• Remove each transit bolt by pulling out of the hole.
• Once all transit bolts have been removed, fit the supplied
hole covers in the empty holes.
Levelling the appliance
• Check that the adjustable feet of the appliance are flat against the appliance, to do this turn in
a clockwise direction.
Important: Do not replace the adjustable feet with castors.
• Once the appliance is in the correct position, push down on each
corner to see if there is any movement. If movement is found,
it means that the appliance is not level and the adjustable feet
will need readjusting.
• To loosen the adjustable feet turn in an anti-clockwise direction
• Push down again on each corner to see if there is any movement,
if movement is found repeat the above sequences again.
WARNING: The drum of the appliance spins at a very high
speed, if the appliance is not level and on a solid floor it may
cause loud noise, vibration and unwanted movement in the appliance.
Connecting the Inlet hose
• Connect the inlet hose to the water tap and fasten in an
anticlockwise direction.
• Connect the other end of the inlet hose to the inlet valve
found on the back of the appliance and fasten tightly in a
clockwise direction.
• If there are any leakages repeat the above sequences
ensuring that all connections are tightly fastened.
• The appliance must be connected to a cold water supply.
Important: Do not bend or kink when installing the hose