22
Page
TEMPERATURE REMOTE CONTROLLER
-Optional item-
<Mounting and wiring the remote controller>
1. Take off the “
Back plate
” from the remote controller with a flat head screwdriver.
(Fig. A and B)
2. Attach the “
Back plate
” on the wall with the two provided screws.
(Fig. B)
Fig. B
Back plate
3-1/4 inches
(82.6 mm)
Attach the screws
Cut out the partition with pliers
Main body
Fig. A
Main body
Twist
Press and twist flat head
screwdriver against the cutout.
This remote controller is NOT waterproof.
The water heater can only have one remote controller.
Do not install in high temperature environments, high humidity conditions out-
doors, in direct sunlight, or within the reach of children.
Make sure the remote controller does not come into contact with water or oil.
•
Do not place the remote control wiring close to other wires from other
products.
•
Do not extend the remote control wiring more than 400 ft. (122 m.)
CAUTION
-INSTALLATION-
Installation
Installation Manual
Verify that the items listed below are included with the remote controller.
Temperature
remote controller*
Screws
Manual
Qty: 1
Qty: 2
Qty: 1
*
9009069005 (TM-RE42)
