Page 12
Page 13
STROBE CH :
Enter this sub-menu to select the behavior of the strobe channel:
• [ON] -
LEDs are ON when the strobe channel is at 0.
• [OFF]
-
LEDs are OFF when the strobe channel is at 0.
INFO
[Time.Info] -
Usage Time
• [Current]
: Display of usage time (in hours) since last power-on.
• [TotalTime]
: Display of usage time (in hours).
• [Last]
: Display of the time of use (in hours) since the last time reset.
• [PASSWORD]
: To access the usage time reset, you must enter a
PIN code: 050 to reset
[Last]
value.
[Clear]
:
[ON]
to reset
[OFF]
to cancel
[Temp.Info]
- Temperature display
• [LED temp]
: xxx F or C - LED temperature display
[Err.Info]
- sensor errors
• [None]
: No error
• [Zoom]
: Zoom Sensor error
• [Temp]
: LED temperature sensor error
[ModelInf]
- Displaying the projector model
[ParKolor 200 HD]
[Software]
- Firmware version display
[Vx.xxx]
MANUAL :
[Reset.M]
- Enter this sub-menu to reset the Zoom.
[ManCtrl] -
Manual control
Allows you to create a luminous state. Adjust the following parameters to create a state.
Validate with
[Enter]
each parameter.
• [Dimmer]
: from 000 to 255 adjust overall Intensity.
• [Strobe]
: from 000 to 255 adjust the Strobe.
• [Zoom]
: from 000 to 255 adjust the Zoom.
• [Red]
: from 000 to 255 adjust the red Intensity.
• [Green]
: from 000 to 255 adjust the green Intensity.
• [Blue]
: from 000 to 255 adjust the blue Intensity.
• [White]
: from 000 to 255 adjust the white Intensity.
[Calibrate]
Sub-menu allowing to recalibrate the various parameters of the ParKolor 200 HD.
To access this menu, you must enter the PIN code to unlock this function.
Pin Code : 050
This gives access to the various parameters.
