2
Getting Started
This section is to help you prepare the USB100BT for
installation. Please read through this section carefully
before attempting to install the USB100BT.
Unpacking the USB100BT
1 x Ethernet adapter
1 x USB A-B cable
1 x Driver disk
Installation
Hardware Installation
1. Connect the RJ45 connector of the USB adapter to
the 10/100Mbps hub/switch of your LAN by using
a twisted-pair cable (maximum length 100 meters).
Use Category 3, 4 or 5 cable for 10Mbps Ethernet
and Category 5 cable for 100Mbps Fast Ethernet.
2. Connect the USB Type B connector is the USB
adapter and your PC’s or USB Hub’s USB Type A
connector by using the standard USB cable
(maximum length 5m).
Software Installation
The drivers and utilities are supplied on the diskette
included in this package.
Before you install the USB device driver, you must
first make sure that your computer’s USB controller
device has been properly detected and configured
under Windows. Also make sure that the USB port is
enabled. Check your computer’s user’s manual for
