Connecting Computers to the KVM Switch (SV211KUSB)
This section describes how to connect the computers you wish to control, to the KVM
switch.
1. Remove any existing keyboards, mice, monitors, speakers, and microphones from the
computer(s).
2. Using a USB + Video Data Cable, connect one end (blue) to the
Video Out
connector
on
Computer 1
. (This will be the same connector from which you disconnected the
monitor in step 1, if applicable.) Connect the opposite end to the VGA port on the
back of the KVM Switch.
3. Plug the USB portion of the USB + Video Data Cable into an available USB port on
Computer 1
.
4. Optional: If you wish to use audio, connect the Speaker/Microphone combination cable
to the
Mic
and
Speaker out
ports. Insert the opposite end of the cable (USB mini-B)
into the port located on the side of the switch denoted as
PC1.
5. Repeat the above process to connect any further computers.
Instruction Manual
3
SV211KUSB Shown
Figure 1-2
USB + Video Data Cable
Microphone
Speakers
USB to Audio cables
PC 2
PC 1
Console
