StarTech.com ST128UTPR, Инструкция по эксплуатации

Страница: 7 / 9

5
Receiver, switch it off and/or disconnect it.
Symptom: The remote display does not display an image when the local computer
connected to the VGA Extender wakes up from Standby Mode.
Remedy: Power the remote display OFF and ON again.
Symptom: The image on the remote display is distorted, noisy, or displays a “signal
error” or similar error message.
Cause: The screen resolution and/or refresh rate on the local computer connected to the
VGA Extender may be set too high for the capabilities of the remote display.
Remedy: (1) Adjust the local computer connected to the VGA Extender to a lower
resolution and refresh rate until the remote display shows an image.
(2) Gradually increase the resolution and refresh rate until the remote display
ceases to display an image.
(3) Return the resolution and refresh rate on the local computer connected to
the VGA Extender to the highest resolution and refresh rate setting that
displayed an image on all remote displays.
NOTE: If you are still unable to see an image on the remote display after trying the
above solutions, it is recommended that you verify the Category 5 Ethernet cable
installation to the remote display before calling technical support. This can be used
using a standard cable tester. If you do not have a cable tester, contact a local computer
service or wiring professional.
Specifications
Resolution Up to 1600 x 1200 @ 75Hz
(can be affected by overall cable length)
I/O Video Signals Analog signal: red, green, blue 0.7v p-p 75 Ohm
Sync TTL Compatible
Horizontal/Vertical Positive/Negative
Sync Polarity
System Cable Category 5 Shielded FTP Cable
Maximum Distance 360 feet (110 meters)
Operating Temperature 41°F - 104°F (5°C - 40°C)
Connectors VGA Out: HDD15F (for display)
VGA In: HDD15M (for computer, optional)
RJ-45
Power Self-Powered (via Ethernet cable)
Dimensions 1.32” x 3.12” x 0.84”
34mm x 85mm x 73mm