Instruction Manual
4
6. Fasten the rear panel to the enclosure casing on both sides using the screws
(2) provided.
7. Once the drive has been secured within the Enclosure, connect the DC power
adapter to the DC power port. Connect the remaining end of the power adapter to
an available electrical outlet.
8. Connect the USB cable to the USB host port on the rear panel of the Enclosure then
connect the remaining end of the cable to the host computer.
NOTE:
If no host connection is detected (USB cable unplugged or computer turned
off), the enclosure will automatically go into Suspend Mode and power down the SATA
drive until an active host connection is detected.
9. With the host computer powered on, power on the Drive Enclosure using the On/
Off switch. The operating system will automatically detect and install the SATA drive.
Once complete, the drive should be ready for use.
NOTE:
The enclosure will automatically go into Suspend Mode if the connection is left
idle for more than 5 minutes. The SATA drive will be powered down but still visible
to the operating system. Accessing the SATA drive will automatically cancel Suspend
Mode and power the drive back up.
Driver Installation
No driver installation is required for the compatible operating systems, as this
enclosure is natively supported, so the drivers are already installed.