Instruction Manual
2
Installation
WARNING!
Hard drives and storage enclosures require careful handling,
especially when being transported. If you are not careful with your hard disk,
lost data may result. Always handle your hard drive and storage device with
caution. Be sure that you are properly grounded by wearing an anti-static
strap when handling computer components or discharge yourself of any
static electricity build-up by touching a large grounded metal surface (such
as the computer case) for several seconds.
Hardware Installation
1. Remove the 4 small screws from the bottom of the enclosure. The two halves of the
enclosure should now pull apart.
2. Place the 2.5” SATA drive into the half that contains the SATA connector and slide the
drive onto the SATA connector.
3. Reassemble the enclosure by placing the two halves together and replacing the 4
small screws from the bottom.
4. Connect the USB cable from the enclosure to the host computer system.
Driver Installation
No driver or software installation is required for any operating system with USB
support. This enclosure, however will only operate at the speed level of the USB port it
is plugged into (i.e. USB 1.x/ 2.0/ 3.0).
