StarTech.com PCISCSIU2W, Инструкция по эксплуатации

Страница: 5 / 11

Installation
This section will guide you through the installation of your PCI card and the related
software. Please read through the instructions carefully and complete each step in the
order listed.
Installing the Card
1. Make sure that your system is unplugged and you are grounded.
2. Remove the cover of your system (see your computer's user manual for details, if
necessary) and gently turn your computer onto its side.
3. Locate an empty PCI slot (usually white in colour) and remove the metal plate that
covers the rear bracket. You may need a Phillips screwdriver to perform this step.
Retain the screw! You will need it to secure the card later.
4. Gently insert the card into the empty slot, making sure it is firmly seated.
5. Secure the card in place using the screw you removed in Step 3.
6. Physically install your SCSI devices into your case, following the instructions in their
documentation. If you need more information about connecting and terminating your
devices on the SCSI card, please see the next subsection, “Connecting and
Terminating Your SCSI Devices” below before closing the case. Otherwise, connect
the data cables to both the card and your devices(s) as needed, and complete step 7.
7. Put your computer case back on.
NOTE: You may also wish to use the card’s integrated SCSI BIOS utility to view and
configure SCSI devices attached to the card. You can access this utility by following the
on-screen instructions at boot-up.
Instruction Manual
2
PCI
Slots