StarTech.com EOC110K, Инструкция по эксплуатации

Страница: 6 / 10

Instruction Manual
3
Installation
Hardware Installation
NOTE:
Both of the converter boxes in the EOC110K kit are identical, so they can be
installed at either end, in any order.
1. At one of the locations for the converter box, connect an RJ45 Ethernet cable from
the existing Ethernet network or computer network adapter to the “LAN” port on
the converter box.
2. Connect the coax cable to the “Link” F-Connector on the converter.
3.
OPTIONAL:
If also transmitting analog cable TV signals over the coax line, connect
the CATV F-Connector to a TV or TV receiver. Digital cable TV signals are not
supported.
4. Connect the included power adapter. The power LED should light up solid. The
LAN Link/Act LED should light up solid when successfully connected to an Ethernet
device on the “LAN” port.
5. Setup additional converter boxes by following the same Steps 1~4 for each location.
6. Once all units are setup, they should be able to automatically locate one another
over the coax cabling. The Coax Link and Sync LEDs should stay solid once
communication is established. The Coax Link LED will flash during communication.
7. The devices plugged into the “LAN” ports should now be able to communicate with
one another freely.
Driver Installation
No driver or software installation is required for these converters on any connected
computer systems.