A
As
ss
se
em
mb
blliin
ng
g Y
Yo
ou
urr C
Co
om
mp
pu
utte
err
WARNING:
Do not attempt to install any computer components with the system plugged
in.
Never open your computer case when your system is turned on. Always make
sure that the computer is off and unplugged before attempting to assemble or alter
your computer.
Computer equipment can also be severely damaged by static electricity.
Be sure that you are properly grounded before opening your computer case or touching
any components. StarTech.com recommends that you wear an anti-static strap when
installing any computer equipment. If an anti-static strap is unavailable, discharge
yourself of any static electricity build-up by touching a large grounded metal surface
(such as the computer case) for several seconds. Also be careful to handle expansion
cards and motherboards by their edges and not the gold connectors.
NOTE:
This section is intended as a guide only. When installing computer components,
be sure to refer to the manufacturer’s installation documentation before attempting to
install the parts.
Removing the Cover from Your Case
1. Make sure that the case is not plugged in and that you are properly grounded.
2. Gently lay the case on its right side.
3. Simultaneously pull the two green tabs upwards and slide the panel back then lift off
towards you so it is entirely removed from the case.
Closing Your Case
1. Turn the panel so that the two tabs are aligned with the back of the computer.
2. Gently slide the panel into the case until it clicks into place. Make sure that the ridge
on the back of the panel is properly aligned with the computer case. When the panel
is correctly in place, it will be flush with the rest of the case and can not be removed
without unlocking the tabs.
Installing Your Motherboard
NOTE:
Please refer to your motherboard manufacturer’s installation procedures to ensure
proper installation of your motherboard.
1. Open your case using the procedure described above (please see
Removing the
Cover from Your Case
).
2. If your motherboard comes with an input/output panel (the collection of ports on
the back of your system) that is different than the panel provided by StarTech.com,
remove the StarTech.com input/output panel by firmly pressing it from the outside
until it pops free. Insert the new input/output panel according to the
manufacturer’s instructions.
Instruction Manual
2
