STARPLUS STSe Key System, Руководство по установке

Страница: 80 / 94

4-12 Remote Maintenance
Chapter 4 - Maintenance and Troubleshooting
STARPLUS STSe - Installation Manual August 2005
CO Line Configuration
Figure 4-4 is a configuration of the STSe system and displays what is printed for
Slot 5 when the following occurs:
an LCOB is installed in that slot,
-and-
the installer types d<space>s5 at the
maint>
prompt.
Figure 4-4: CO Line Configuration
Column Indicates the following …
1 CO Line Number
2 Status
OOS status can indicate the entire card is o ut o f s ervice.
INS status can indicate a board station is in-s ervice and operating correctly.
Incoming = Incoming CO line calls are allowed
Outgoing = Outgoing CO line calls are allowed
Bothway = Both incoming and outgoing CO line calls are allowed
EXAMPLES
† Outgoing Enabled indicates the CO line is active in the system.
† Outgoing Disabled indicates that the Attendant has disabled the CO line for
outgoing access.
3 CO Line Group Number
4 CO Line Type
0 = None
1 = Data
2 = Loop Start
3 = Ground Start
4 = DID
5 = TIE
6 = TIE-DNIS
7 = TIE-ANI
5 Whether CO Line is Pulse or DTMF (programmable option)
6 Whether Line is a CO Line or a PBX Line (programmable option)
7 CO line State
maint>d s5
SLOT CARD CKTS SERV STAT BRD OPTS FW VER.
--------- ---- ---- ----------- ---------- ---------
05 LCI4 3 OOS 0 -0
CO-PORT STATUS Grp Type PULSE/DTMF CO/PBX STATE
-------- ---------------------- ---------- ------ -----
5-020 OOS, Bothway 1 2 DTMF CO WIDLE
6-021 OOS, Bothway 1 2 DTMF CO WIDLE
7-022 OOS, Bothway 1 2 DTMF CO WIDLE