STARPLUS STSe Key System, Руководство по установке

Страница: 77 / 94

Remote Maintenance 4-9
Chapter 4 - Maintenance and Troubleshooting
STARPLUS STSe - Installation Manual August 2005
Remote Maintenance
General Overview
The Remote Maintenance feature allows authorized personnel to survey system, slot
configuration information and programming. This can be done through the optional modem.
The commands are entered from a keyboard.
Maintenance Command Format
There are four basic commands available in the Remote Maintenance feature. All commands
begin with a single character, followed by a space, another character and an optional digit or
digits. All commands are terminated with the <Enter> key.
Maintenance Password
The Maintenance feature, like Programming, is entered via a six-character alphanumeric string.
The password prompt is given by pressing <Enter> at the device connected to the RS232-1 port
(COM1) of the BKSU or connected to the modem. After the prompt displays, enter the
password, then press <Enter>. Proper entry of the password displays the maintenance prompt.
»
The Maintenance password is: config
Exit Maintenance
The Exit command terminates the current Maintenance feature session.
»
The Exit command format is: maint>x
Figure 4-1: Maintenance Help Menu
maint>?
command list:
c - clear log error trace
d s[nn] - dump system or slot configuration data
[nn] specifies an optional slot number parameter
no parameter indicates that the entire system will be
dumped examples:
maint>d s (dumps entire system configuration)
maint>d s2 (dumps slot 2 configuration, etc.)
d b (dumps busy device.)
d e (dumps event trace.)
d p (dumps pp que error counts.)
r cxxx (reset coline)
r kxx (reset cab/slot)
r sxxx (reset station)
d r (dumps RCVR configuration.)
d r01 (toggle RCVR 01 stat & dumps configuration)
f p (flush pp que error counts)
t0..4 - set trace (off,soft start,cold start,soft/cold start,error log
x - exit maint
? - help menu