Blade Set
Hardware
kit
3 Screws
Wall
mounting
bracket
Retaining
Nut
2
PART NAMES
GUARD & FAN BLADE ASSEMBLY
1. Unscrew and remove the spinner clockwise (or obtain from
parts bag), and the plastic nut counterclockwise (Fig. 2). You
may have to hold the shaft in place with one hand to unscrew
the spinner with the other. Mount the rear guard against the
motor face so that the pin at the motor face bottom fits through
the tear drop hole in the rear guard mounting ring. When correctly mounted
the set of two tabs on each side of the motor face will also fit through their
designated holes in the mounting ring, and the rear guard will rest flat and
evenly on the motor face. Screw the plastic nut back onto the motor face to
secure the rear guard in place. Fig. 1
2. Mount the blade set onto the motor shaft through the center hole in the blade
set. Insert the retaining pin on the motor shaft into the slots in the Blade set
core. Turn the spinner counterclockwise onto the shaft to tighten the blade set
into place. Fig. 3
3. Open the five latch clips on the rear guard. Align the logo on the front guard
so that it will read horizontally. Insert the edge of the front guard into the
fixed clip at the bottom of the rear guard. Use the five latch clips to secure the
two guards together. Fig. 4
4
.
g
i
F
3
.
g
i
F
2
.
g
i
F
Fig.1
