Starke ST-01225, Инструкция по эксплуатации

Страница: 13 / 17

E-SHOP dOwnlOad
shop.haberkorn.com
13/1
GB
I
I
N
N
S
S
T
T
A
A
L
L
L
L
A
A
T
T
I
I
O
O
N
N
A
A
N
N
D
D
U
U
S
S
E
E
Unpacking:
¾
After opening the carton, carefully inspect the hoist frame, cords, hooks and
control units, etc. for damages, which may have occurred during shipment.
Installation (see fig. 4)
¾
The hoist is provided with an installation system that allows it to be mounted
on a rectangular beam.
¾
The dimension of the rectangular beam must be in accordance with the
position and dimension of the installation holes of the hoist and ist strength
can hold the rated load.
¾
It is recommended to turn to a skilled technician for help and inspect the
solidity of the beam structure.
¾
The fastening screw must be properly tightened.
¾
Before utilization, a skilled technician should check that the support system
and the coupling of the hoist are well sized.
Utilization of pullery block (see fig. 5 and 6)
¾
The hoist is provided with an extra pully and hooks, and when they are used
correctly, the machine can hoist double load.
¾
Assemble the pulley with help of bolts as shown in the picture.
¾
The hook originally fixed on the machine can be attached to the racks opening
which is designed fort his purpose.
¾
With help of 2 steel cables to lift the load, the machine is now capable of
hoisting a double load.
Operating Instructions
1. Before the machine is used for the first time, remove the adhesive tape for
fixing steel cables from the cable drum.
2. The value of the equivalent sound emission pressure level at the operator’s
position is lower than 85 dB.
3. For the machine, the supplying power requirement is as follows: the voltage is
rated v 10% and the frequency is rated fre1%
4. The hoist is used at ambient temperature of 0°C – 40°C, and the relative
humidity of air at 25°C is not higher than 85%. The sea level where it is used
is not higher than 1000 m.
5. The transportation and storage temperature of the hoist may be above -25°C
and below 55°C, with the highest temperature of not higher than 70°C.
6. The user shall lift the load from the ground with the lowest seed. When a
heavy weight is lifted from the ground, the steel cable shall be in tense state
instead of slack state.
7. The motor of the hoist is equipped with a overheat switch.
8. During operating, the hoist may Stopp running, and it will become operational
again only after a break for the motor to cool down.