Output connections, trigger, and power
Connect up to 8 speakers using the corresponding output binding posts. Speaker wires
can be terminated with “banana plugs” which are inserted, or stripped insulation (unscrew
binding post cap, insert wire into hole on threaded shaft and tighten cap). Observe correct
polarity (“+” red and “-“ black).
The amplifier can be turned-on automatically by, for example, your preamp/processor by
connecting a 12-volt trigger wire to TRIGGER IN (top right). You can use TRIGGER OUT to
connect a “downstream” component such as another amplifier to also be turned-on
automatically. Connect the power cord to AC INPUT (bottom right) and plug the other end
into a 120-volt wall socket. (Customers in countries with 230-volt mains supplies need to
order the 230-volt version of this amplifier, and provide their own power cord.) Right
beneath the AC INPUT is a fuse receptacle. If it blows, replace this fuse only with one of the
same rating. Set the rocker switch to ON to power-on the amplifier.
Operation
Vertical light on the front panel should be green. If it turns yellow, power-off, wait, then
restart.
