14
3.
Power switch
Ensure that the power switch is in the OFF position. If the plug is connected to a power
receptacle while the power switch is in the ON position, the power tool will start
operating immediately, inviting serious accident.
4.
Extension cord
When that work area is removed from the power source, use an extension cord of
sufficient thickness and rated capacity. The extension cord should be kept as short as
practicable.
5.
Feeding oil (refer to the paragraph on oil feeding) Prior to using the power tool,
remove the oil gauge and do not fail the oil tank with the provided oil. (Although the oil
tank is built in, it contains only a small volume of oil when shipped from the works.)
6.
Mounting a tool
When handling bull point, cold chisel and other accessories. It standard tools are
recommended for better operation.
Rotate the stop lever 180 in a clockwise direction while pulling it toward you. Next, insert
the tool shank into the hexagonal hole on the front cover.
Clamp the tool by turning the stop lever half a turn in the opposite direction.
When removing the tool, follow the above procedure in reverse order.
HOW TO USE THE HAMMER
1.
After placing the tip of the tool in the base hole, switch ON.
In some cases, it is necessary to punch the up of the bit against the crushing position
forcibly in order to begin the striking stroke.
This is not due to malfunction of the tool. It means that the safe guard mechanism
against no-load striking is working.
2.
By utilizing the weight of the machine and by firmly holding the hammer with
both hands, one can effectively control the subsequent recoil motion. Proceed at a
moderate work rate, the use of too much force will impair efficiency.
Caution: Sometimes the tool does not begin the striking stroke even when the motor
rotates because the oil has become thick.
If the tool is used at low temperatures or if it is used after a long time idle, the tool shuld
be used running in for five minutes in order to warm it up.
OIL FEEDING
Caution: Prior to oil feeding, always disconnect the plug from the power supply
receptacle.
Since an oil chamber is built in this type Electric hammer, it can be used for
approximately 20 days without supply lubricating oil, assuming that the Hammer is used
continuously 3-4 hours daily. Feed oil into the oil tank as described below before using
Автотовари
«130»
130.com.ua
