Stark 53500, Инструкция по эксплуатации и правила безопасности

Страница: 4 / 15

3
IMPORTANT SAFETY INFORMATION
Use Only Accessories Designed For This Drill Press To Reduce The Risk
of Serious Injury From Thrown Broken Parts Or Work Pieces
When cutting large diameter holes:
- Clamp the workpiece firmly to the table. Otherwise the cutting may grab and spin it at high speed.
- Use only one piece, cup-type, hole cutters.
-
DO NOT
use fly cutters or multi-part hole cutters as they can come apart or become unbalance in use.
- Keep speed below 1500rpm.
Drum sanders must never be operated on this drill press at a speed greater than 1800rpm.
DO NOT install or use any drill that exceed 7” in length or extends 6” below the chuck jaws. They can
suddenly bend outward or break.
Do not use wire wheels, router bits, shaper cutters, circle (fly) cutters or rotary planers on this drill press.
Kickback
Kickback is the grabbing of the workpiece by the rotating tool. The workpiece can be thrown at a very
high speed in the direction of rotation. This Can Cause Serious Injury. To reduce the possibility of injury
from kickback:
- Clamp the workpiece firmly to the table whenever possible.
- Buffing or sanding wheels or drums should be contacted on the side moving away from you, not the
side moving toward you.
- Use only recommended accessories and follow the instructions supplied with the accessory.
This drill press has 16 speeds
See inside of guard for specific placement of
belt on pulleys
If any part of your drill press is missing, malfunctioning, has been damaged or broken…such as the motor
switch, or other operating control, a safety device or the power cord, turn the drill press off and unplug it
until the particular part is properly repaired or replaced.
NEVER place your fingers in a position where they could contact the drill or other cutting tool if the workpiece
should unexpectedly shift or your hand should slip.
To reduce the risk of injury from parts thrown by the spring, follow instructions exactly as given and shown
in adjusting spring tension of quill.
Turn the motor switch off and put away the switch key when leaving the drill press.
To reduce the risk of injury from thrown work or tool contact, do not perform layout, assembly or setup work
on the table while the cutting tool is rotating.
Any power tool can throw foreign objects into the eyes. This can result in permanent eye damage. Everyday
eyeglasses have only impact resistant lenses. They art not safety glasses.
WARNING : Don’t allow familiarity (gained from frequent use of your drill press) to cause a careless mistake.
Always remember that a careless fraction of a second is enough to cause a severe injury.
Noise levels vary widely. To reduce the risk of possible hearing damage, wear ear plugs or muffs when
using drill press for hours at a time.