10
CLEANING DRAIN CLEANER CABLES
1.
Thoroughly flush the drain cleaner cables with clean water after every use.
Turn the power switch
OFF
and unplug the drain cleaner before performing any
maintenance.
ALWAYS
wear safety goggles and gloves while performing any maintenance.
2.
Once cables have been flushed, carefully tip the drain cleaner forward to empty out any remaining debris.
3.
Once the cable is clean and dry, pull the cable from the drum.
4.
Lubricate with an oily rag as you feed the cable back into the drum.
WARNING: DO NOT
attempt to remove a rotating cable.
CLEANING AND LUBRICATING HOUSING
1.
The drain cleaner should be cleaned as needed with hot soapy water and/or disinfectants.
2.
Dry the drain cleaner before storing or using again.
3.
Once dry, thoroughly lubricate with a lightweight machine oil.
4.
If the drain cleaner drum os removed or changed, grease the bearings with general purpose grease.
WARNING:
Risk of shock!
DO NOT
allow water to get into the motor or any other electrical components.
REMOVING AND INSTALLING THE BELT
1.
Loosen the belt gaurd knob and slide belt gaurd off from the top of the clenaer’s motor.
2.
Use a screwdriver to slide the belt off the back of the cleaner’s drum.
3.
Slide a new belt into the belt pulley above the drum.
4.
Slide the new belt onto the rear of the drum until securely in place.
SPECIFICATIONS
MAINTENANCE
Содержание 45074
Страница 12: ...11 TROUBLESOOTING ...
Страница 13: ...12 PARTS ...
