Clockwise pressure ratio increases the score (about 110: 1), the output voltage
become low, 100V input voltage, for example the partial pressure than to
maximum (110:1), the display of 45V block.
Counterclockwise points pressure ratio (minimum about 40:1), namely the high
output voltage and 100V input voltage, for example the partial pressure than to
a minimum (bound), the block is shown as 125V.
Partial pressure ratio adjustment potentiometer factory of 50:1, try not to
adjust.
24V Positive
Start arc control Partial pressure
output
24V
ground
9 core outlet
9
4
6
2,5
Screw
terminal
24+
ST
V
24-
4. Parameters shows
There are three commonly used parameters and two debugging: 1. Set
voltage. 2. Starting arc delay. 3. Locate latency. These parameters can be
directly set corresponding knob on the panel to adjust adjustment.
1. Set voltage, this can at any time by the knob to adjust the "height", on the
left side of the digital tube display voltage value set, the unit: (V), clockwise
to increase the voltage, counterclockwise to reduce voltage. Automatic
Type
