Pri HDD : OK T
Sec HDD : OK
Pri HDD : OK
Sec HDD : OK F
9
The LCD Display Message During Hot Swap and Auto Rebuilding
When the SR2611 detects a hard drive missing or a hard drive failure, the Buzzer will go off and the LCD display
screen will display the following messages:
1. After removing the failed hard drive and replacing with a new hard drive, if the hard drive is properly installed, the
LCD display screen will display the following messages:
2. After few seconds of installing the new hard drive, the LCD display screen will display the data rebuilding
progress:
Pri->Sec represents that the data in the original hard drive (primary hard drive) is copied to the new hard drive
(secondary hard drive). XXX % represents the rebuilding completion percentage.
3. When the rebuilding is fully completed, the LCD display screen will again display the following messages:
4. When SR2611 is overheating, "T" will be displayed on the upper right-hand corner of screen
(As shown in illustration)
5. When cooling fan module is not functional, "F" will be displayed on the lower right-hand corner of screen.
(As shown in illustration)
Hard Disk status on LCD screen
Pri HDD : OK
Sec HDD : Fail
Pri HDD : OK
Sec HDD : OK
Pri HDD : OK
Sec HDD : OK
Rebuilding …
Pri->Sec XXX%
Rebuilding …
Sec->Pri XXX%
Pri HDD : Fail
Sec HDD : OK
