Starcraft Telluride 2021, Руководство пользователя, Страница: 118 / 169

116
Section 8: Plumbing System
/ tank fill valve at the utility center is not used for this operation. It can remain in the CITY
position. Refer to Winterizing the Plumbing System .
Sanitizing (with 6 in 1 Utility Center)
When to sanitize:
 When your RV is new.
 At the beginning and end of each season.
 When the water system becomes contaminated or every three months of use.
Preparing to sanitize
Prepare a chlorine solution using 1/4 cup of household bleach (sodium hypochlorite solu-
tion) to one gallon (3.785 liters) of water in a container. Prepare one gallon of solution for
every 15 gallons of tank capacity.
This will result in a residual chlorine concentration of 50 ppm in the water system and
should remain in system for at least 4 hours. If a 100 ppm concentration is prepared, use ½
cup of household bleach with one gallon of water. One gallon of the solution should be used
for each 15 gallons of tank capacity. Allow to remain in system for at least 1 hour.
How to sanitize
1. Turn both the electric and LP gas water heater switch(es) to OFF. Set th e water heater
bypass valves to BYPASS : Refer to the appropriate water heater bypass diagram for
your model.
2. Level the RV and drain the fresh water system. See
Draining the Fresh Water System.
3. Close the low point drain valves and the fresh water tank drain valve.
4.
Pour the sanitizer solution into the gravity fill inlet on the outside of the RV. Make sure
the fresh water tank drain is closed.
5. Finish filling the water tank with fresh water. Water can be poured into the gravity fill
inlet or it can be power filled through the utility center. Instructions on how to fill the
tank both ways can be found previously.
6. Turn off and disconnect the hose from the water source first, then disconnect from the
utility center. Blue valve position on the utility center will not matter for next steps.
7. Siphon valve at the water pump should be OFF, and the water tank shutoff valve ON.
8. Turn the water pump ON. Water will be drawn from the tank into the water lines.
9.
Open a hot water faucet until water begins to flow continuously and a chlorine smell is
noticeable then close the faucet. Repeat this for all hot water faucets in the RV. Include
outside shower faucets (if so equipped). Include outside kitchen faucet if equipped.
10. Open a cold water faucet until water begins to flow continuously and a chlorine smell is
noticeable then close the faucet. Repeat this for all cold water faucets in the RV. Include
outside shower faucets (if so equipped). Include outside kitchen faucet if equipped.
11. Turn the water pump OFF.
12. Let the solution remain in the tank and lines for at least four hours when disinfecting
with 50-PPM residual chlorine. If a shorter time period is desired, then a 100-PPM
chlorine concentration should be permitted to sit in the system for at least one hour.
NOTE: Fresh water tank sizes vary by model. Contact your dealer
or Customer Service for your specific tank size.
Table of Contents Maintenance Record