OPERATION
START-UP
When the unit is first turned on it will begin the PRE-HEAT mode. The current hold temperature will
be displayed for 3 seconds, then “PHT” (PREHEAT) will flash along with the “HEAT ON” lamp until
the unit has reached its preset hold temperature. When this has been reached, the audible alarm will
beep 3 times, the “HEAT ON” lamp will stop flashing and the display will read “RDY”.
COOKING
Load the unit with the product, (thawed not frozen) Press the “COOK” button to begin. The “COOK”
light will remain on and the Temp light will be on as the unit call for heat. “COOK” will display for 3
seconds, and then the internal cook timer will begin counting down.
Close the drawer.
When the timer reaches 00:00, the audible alarm will beep 3 times.
Then you have two options:
1. Remove the product immediately from the Thermal Vection and place in on your preheated
roller grill for display, then press the “RESET” button. This will take the temperature back to the
PRE-HEAT mode temperature, until you are ready to cook again.
2. Leave the product in the Thermal Vection until you are ready to serve, the unit will maintain the
HOLD temperature and an internal timer will begin to count down, after 3 hours an audible alarm
will sound for 3 seconds and the display will flash “DoNE” until the RESET button is pressed. At
this time the remaining product left in the unit has expired and needs to be discarded.
READING TEMPERATURE
At any point the operator can view the actual temperature by pressing the “TEMP” button. The
reading will be displayed in the temperature mode (°F or °C) which is programmed.
PROGRAMMING THE TEMPERATURE MODE
The temperature mode can be changed from °F to °C or °C to °F by pressing and holding the “TEMP”
button while turning on the main power switch. The set-point temperature that is displayed will be in
the changed temperature mode.
PROGRAMMING HOLD / PREHEAT TEMPERATURE MODE ( F / C)
The HOLD / PREHEAT temperature and hold time can be programmed using the following steps.
The default HOLD temp and TIME are 140°F (60°C) for 3 hours.
1. Simultaneously press and hold the “TEMP” and “HOLD” buttons for approx 3 seconds.
2. The display will show “----“
3. Release the buttons.
4. Enter the 4 digit security code. (4,3,2,1)
5. Once completed, the current hold / preheat temperature will be displayed.
6. To increase or decrease the temperature use the “UP” or “DOWN” arrows.
7. Press the “TEMP” button to save the change.
8. The current time duration for the HOLD mode is now displayed.
9. Use the “UP” or “DOWN” arrows to increase or decrease the HOLD time.
10. Press the “TEMP” button to save the new HOLD time.
11. Press the “TEMP” button again to exit the programming mode.
