Star SP712 Series, Руководство по оборудованию

Страница: 29 / 40

– 25 –
5-4. Adjustment Mode
There are the following seven adjustment modes.
The device will enter the adjustment mode if your turn it on while pressing the FEED switch.
(1) The Self Printing Mode is entered by releasing the FEED switch after the buzzer sounds once. (Refer to Section
"5-4-1. Self Printing Mode".)
(Holding down for 2 more seconds)
(2) Adjusting the Dot Alignment Mode is entered by releasing the FEED switch after the buzzer sounds twice. (Refer
to Section "5-4-2. Adjusting the Dot Alignment Mode".)
(Holding down for 2 more seconds)
(3) The Hexadecimal Dump Mode is entered by releasing the FEED switch after the buzzer sounds three times. (Refer
to Section "5-4-3. Hexadecimal Dump Mode".)
(Holding down for 2 more seconds)
(4) The Black Mark Sensor Alignment Mode is entered by releasing the FEED switch after the buzzer sounds four
times. (Refer to Section "5-4-4. Black Mark Sensor Alignment Mode".)
(Holding down for 2 more seconds)
(5) The Near End Sensor Adjustment Mode is entered by releasing the FEED switch after the buzzer sounds five
times. (Refer to the separate Specifications Manual for details.)
(Holding down for 2 more seconds)
(6) The Memory Switch Manual Setting Mode is entered by releasing the FEED switch after the buzzer sounds six
times. (Refer to the separate Specifications Manual for details.)
(Holding down for 2 more seconds)
(7) The Memory Switch Override Mode is entered by releasing the FEED switch after the buzzer sounds seven
times. (Refer to the separate Specifications Manual for details.)
(Holding down for 2 more seconds)
Returns to (1).