5
2M-Z19213; Rolling T
ortilla W
armer Manual
DAILY OPERATION ELECTRONIC
CHANGING TEMPERATURE
1. Push and hold the "SET TEMP" button for three seconds.
2. The display will flash the current top temperature setting.
3. Using the ↑ and ↓ adjust the drum heat to desired temperature
(increments of 10°)
4. Press the "SET TEMP" button again to change the IR heat setting.
5. Using the ↑ and ↓ adjust the IR heating setting (0 – 10).
6. Press the "SET TEMP" button again to save the settings and exit
program mode.
CHANGING DRUM SPEEED
1. Push and hold the ↑ and ↓ for three seconds
2. Using the ↑ and ↓ adjust the motor speed to the desired
setting (1 through 99)
3. Press the "SET TEMP" button to exit the program
CHECK TEMPERATURE SETTING
1. Press the "SET TEMP" button to check the platen temperature.
CLEAN MODE
1. Press the "CLEAN" button to enter the clean mode
a. Elements will be turned OFF and the drum will continue to turn
b. The screen will flash CLEAN and WAIT.
c. When the drum has lowered to a safe temperature the screen will flash CLEAN and READY.
2. Press the "ON/OFF" button to exit the clean mode.
WARMING PROCEDURES
1. For best results, allow the unit to pre-heat for 30
minutes before using.
2. Place your tortilla onto the Infeed Shelf and slide it
into drum.
3. Your warm tortilla will exit the bottom of the unit.
CAUTION
This unit is designed to warm dry flexable
products only. DO NOT attempt to run wet
loose material through the unit.
RTW
ROLLING TORTILLA WARMER
RUN
SET
ON
OFF
TEMP
CLEAN
DRUM TEMP
HR POWER
IL2887
Above: Shown with Optional Drop Shelf
