8
PILOT FLAME ADJUSTMENT
The griddles are equipped with standing pilots and should be lit immediately after the gas is
turned on.
MANUAL VALVE AND THROTTLING CONTROL MODELS
Adjust the fl ame as low as possible while still providing immediate burner ignition when
the control knob is turned to high.
SNAP ACTION THERMOSTAT AND CHROME SURFACE MODELS
Adjust the pilot so approximately 3/8" of the thermocouple tip is surrounded by
the pilot fl ame.
LIGHTING INSTRUCTIONS
When the griddle is fi rst lit, it will smoke until the preservative oils and impurities are burned
off. The griddles are equipped with standing pilots and should be lit immediately after the gas
is turned on. The Unit should be properly leveled prior to lighting.
DO NOT ATTEMPT TO LIGHT YOUR PILOT BURNER IF YOU EXPERIENCE A
STRONG GAS ODOR.
MANUAL VALVE AND THROTTLING CONTROL MODELS
1. Turn off the main valve to the unit and wait 5 minutes to clear gas.
2. Turn off all knobs and pilot valves.
3. Turn on main valve to unit and light all pilots.
4. Turn burner knobs to desired position.
5. To turn burners off, turn knobs to off.
SNAP ACTION THERMOSTAT AND CHROME SURFACE MODELS
1. Turn all knobs and power switch to "OFF" and wait 5 minutes to clear gas.
Remove any grease trays.
2. Put lighter under the front of the griddle.
FIG 1
3. Look through large hole in front panel.
4. Move Lighter up to the pilot.
5. Put your other hand under the front of
the griddle and press the button on the
saftey valve.
6. Once the pilot is lit, remove the lighter and
continue to press the button for at least
30 seconds. You only need to light one
pilot.
7. Once pilot remains lit, turn the power switch
"ON" and turn all knobs to the "ON" position.
This will light all other pilots.
8. To turn burners off, turn off power
switch.
Pilot
Saftey Valve
IL1200
FIG 1, Place Lighter under griddle
CAUTION
