PSB241.doc Page 3 of 3
Turning off
the “RE-WAX LED” for the TR 3900:
1. Power ON the treadmill.
2. Press the TIME, DISTANCE and SPEED keys simultaneously.
3. Power OFF the treadmill to reset the LED.
4. Power ON the treadmill. The re-wax LED light should be off.
Clearing the “RE-WAX BELT” Message for the TR 4500:
1. Power ON the treadmill.
2. Enter “Maintenance” mode, by holding down the “0”, “2” and “Start” keys at the same time,
and then let go of the “2” only. The display will read “MAINTENANCE SETTINGS”. If you
do not get it to go into the Maintenance mode, press the “STOP” key twice and try again.
Note: This can be difficult. Keep trying.
3. Press the elevation “
↑
” key until the display window reads “LST DCK”.
4. Press the “
♥
” key to enter the distance the treadmill has accumulated.
5. Press the “START” key and the display window will show “UPDATING”. This will save the
accumulated distance in the parameter. The display will go back to “LST DCK” and to the
right of those words will be the accumulated distance.
6. Press the “STOP” key to exit the mode.
7. The “REWAX BELT” message should be gone.
CALL STAR TRAC AT 1-800-503-1221 IF YOU NEED ADDITIONAL ASSISTANCE.
