%$
C
LUTCH
A
DJUSTMENT (NXT SR Only)
1. Using a 3mm Allen Wrench, remove the three screws supporting the
plastic chain guard shroud.
2. Using a 3mm Allen Wrench, remove the four screws supporting the
COG guard cover. (Figure 7)
3. If the torque is not 45 ~ 50 ft-lbs. using a 5 mm Allen Wrench, give
each of the set screws a little clockwise turn. A “little turn” is about 10
degrees. (Figure 8A & 8B)
Note:
•
Be sure and turn all 5 set screws so they have equal pressure
to obtain the proper adjustment. Recheck the torque for
different positions around the clutch. If it is still not 45 ~ 50
ft-lbs, repeat the procedure.
•
The goal is to make all the set screws have the same
pressure on the clutch.
4. Test the clutch system for proper operation for normal riding use.
Observe all safety practices.
Figure 7.
Figure 8A. Figure 8B.
Set
Screws
COG Cover
