– 11 –
ENGLISH
Pause at a: HEX dump
Pause at b: sensor selection
Press ON LINE
1 short beep
Reflecting sensor
Press FEED
2 short beeps
Transmissive sensor
Pause at c: command mode selection
Press ON LINE
1 short beep
Page mode
Press FEED
2 short beeps
Line mode
3) Power + ON LINE + FEED switches
(Turn the power on while holding the ON LINE and FEED switches depressed.)
Approx.
Approx.
Approx.
Approx.
2 sec.
2 sec.
2 sec.
2 sec.
1 short beep … 2 short beeps … 3 short beeps … 1 long beep
…
…
a
b
c
d
e
HEAD UP
NO PAPER
ERROR
LEDs flash
All LEDs
LED
LED
LED
successively
light up
lights up
lights up
lights up
lights up
Pause at a: RAM backup cleared
Pause at b: feed function selection
Press ON LINE
1 short beep
Top of Form disabled.
Press FEED
2 short beeps
Top of form enabled.
Pause at c: sensor adjustment mode
Pause at d: no operation
Pause at e: clearing of all memory switches and test print
1
At e, release the ON LINE switch and FEED switch in 2 seconds
or less (all LEDs go off).
2
Press the ON LINE switch and FEED switch in 2 seconds or less,
and hold them depressed for at least 3 seconds (all LEDs light up).
3
Release the ON LINE switch and FEED switch.
4
The contents of all memory switches will be erased (all will be set
to 0).
After that, test print is carried out.
* If this process is interrupted midway, the printer will operate in
regular mode.
* After the memory switch settings are erased, the memory switches
must be set again, as appropriate for each model.
