OPERATOR’S MANUAL
HOLMAN CONVEYOR TOASTERS
MODELS DT14-PS AND DT14-TH
PAGE 2
UNCRATING AND INSPECTION
Unpack unit and components from shipping container. Remove all visible packing material and inspect unit for
damage. If damage is discovered, contact the carrier that handled the shipment and file a shipping damage
claim immediately.
ASSEMBLY AND INSTALATION
Model DT14-PS/TH is shipped fully assembled and ready to plug into a 50A, 250VAC Twist Lok receptable
such as a Hubbell part number CS8269. Removal or replacement of the power cord and plug will
VOID
the
warranty
.
Consult with a licensed electrician prior to installation.
For assistance, call the Holman Factory
Service Team at 1-800-807-9054.
The toast chute may be installed for either front of rear product discharge as shown below.
The DT14-PS/TH is equipped with an adjustable front heat shutter. This shutter may be adjusted from an
opening clearance of 1½” up to 3”. To adjust shutter, loosen the single Phillips screw on the front of the top
cover, slide the shutter up or down to the desired height and tighten the Phillips screw. The screw for the lower
chamber is located above the conveyor belt on the front of the toaster and can be adjusted in the same
manner.
ADJUSTABLE HEAT SHUTTER
ϑΙϑϑϑΟΙΟ
ϑΙϑϑϑΟΙΟ
ϑΙϑϑϑΟΙΟ
ϑ Ι ϑ ϑϑΟΙ Ο
ϑΙϑϑϑΟΙΟ
ϑΙϑϑϑΟΙΟ
ϑΙϑϑϑΟΙΟ
ϑΙϑϑϑΟΙΟ
ϑΙϑϑϑΟΙΟ
ϑ Ι ϑ ϑϑΟΙ Ο
ϑΙϑϑϑΟΙΟ
ϑΙϑϑϑΟΙΟ
HOLMAN
FRONT VIEW OF TOASTER
