3
GENERAL OPERATING PROCEDURES
The main switch located on the control panel con-
trols all the power to the unit. With the main switch
on, the rollers will turn, but no heat will be sup-
plied unless the heat controls are turned on. For
flexibility the heating section of the grill is divided
into two individually controlled heat sections. The
right control regulates the heat to the rear section
and the left control regulates the heat to the front
section. The switch is lighted to indicate when the
unit is turned on. The LED readout on the controls
indicates the grill's setting. An additional light is
provided on the end housing of the unit. This light
indicates the position of the main power switch
when either the optional bun drawer front or mer-
chandising door obstructs the control panel view.
Bun box equipped models require the removal of
the bun drawer to remove the bun pan and to re-
move the drip tray when access to the rear of the
unit is obstructed. To remove the bun drawer, grab
the drawer by both sides and pull it out all the way.
Lift the front to unhook the drawer slide from rear
drawer roller. Pull the drawer the remainder of the
way out. Use caution not to drop the drawer when
reaching the end of the drawer slide travel. To
reinsert the drawer, first hook the drawer slide over
the front roller then the back roller. Do not operate
the grill without the drip tray in place.
CAUTION
USE ONLY PLASTIC OR COATED UTENSILS
FOR HANDLING THE FOOD PRODUCT.
METAL COULD SCRATCH THE ROLLER
COATING AND EFFECT THE CLEANABILITY
OF THE ROLLERS.
CAUTION
This equipment is designed and sold for
commercial use only by personnel trained and
experienced in its operation and is not sold
for consumer use in and around the home
nor for use directly by the general public in
food service locations. For equipment to be
used by the general public, please contact
the factory.
INSTALLATION
This grill is equipped for the voltage shown on
the nameplate. It will operate on alternating
current only, however, the specified voltage must
be applied.
CAUTION
DO NOT CONNECT TO DIRECT CURRENT
(DC).
CONNECTION LOAD:
MODEL SERIES
WATTAGE
30E, 30SE, 30BBE, 30SBBE
1150
30SE-230V
1150
45SAE, 45SARE
1650
45SAE-230V
1650
50E, 50SE, 50BBE, 50SBBE, 50BBES 1535
75AE, 75SAE, 75ABBE, 75ABBES,
75SABBE, 75SARE 208/240V,
75SAFE
1810/2400
75AE, 75SAE, 75ABBE,
75SABBE, 75SARE 120V
1730
The grill should be connected to a wall type recep-
tacle, a direct line or individual branch circuit. An
individual branch circuit is preferred. If connected
to an overloaded circuit the grill will not operate
properly. The unit should be level when installed.
Models equipped with bun boxes must be level to
utilize the self-closing feature of the bun drawer.
Adjustable 4-inch legs are standard on the 75A
series and available for all other models.
