4
GENERAL INFORMATION
This equipment is designed and sold for commercial use only by personnel trained and experienced
in its operation and is not sold for consumer use in and around the home nor for use directly by
the general public in food service locations.
UNPACKING AND INSPECTION
Unpack the oven and all components from the container. Thoroughly inspect the oven for
damage. If damage is discovered, immediately initiate a claim with the carrier that handled the
shipment. Be sure to remove all the paper protection and packing material prior to heating.
ASSEMBLY AND INSTALLATION
The ovens are shipped with adjustable feet detached. Install the feet by placing the oven on
its side and screwing the feet into the threaded holes on the bottom of the unit. Contact the
factory for alternate installation methods.
WARNING
This appliance is equipped with a three-prong (grounding) plug for your protection
against shock hazard and should be plugged directly into a properly grounded
three-prong receptacle. Do not cut or remove the grounding prong from this
plug.
CAUTION
IMPROPER INSTALLATION, ADJUSTMENT, ALTERATION, SERVICE, OR
MAINTENANCE CAN CAUSE PROPERTY DAMAGE, INJURY, OR DEATH. READ
ALL INSTRUCTIONS THOROUGHLY BEFORE INSTALLING OR SERVICING THIS
EQUIPMENT.
The oven is equipped with a thermostat that interrupts power to the heating elements if the
temperature in the control compartment is excessive. Do not obstruct the ventilation openings
on the side panel. These provide cooling air for the controls. If airflow to the fan is obstructed,
the thermostat will need to be reset by pressing the reset button on the upper left side of the
rear panel.
LOOSEN SCREWS IN TOP COVER TO
ALLOW WALL MOUNTING BRACKETS
TO SLIDE BENIETH BACK EDGE OF
TOP COVER.
LEAVE APPROXIMATELY
1/8" OF BOLT HEAD
EXPOSED FOR MOUNTING
WALL MOUNT BRACKET
TO WALL.
MOUNTING
BOLT. MOUNTING
BRACKET SLIDES OVER
HEAD OF BOLT.
WALL
STUD
MOUNTING BRACKET SLIDES
BENIETH BACK OF TOP COVER
BACK OF UNIT
LEG SCREWS INTO
WELD NUT ON BOTTOM
OF UNIT FOR COUNTER
MOUNTING.
CAUTION
DO NOT INSTALL WITHOUT FEET PROVIDED.
The ovens are equipped for the voltage indicated on the nameplate mounted on the bottom
panel. They will operate on alternating current (AC) only.
