-3-
To change patterns, press the pattern select button on the cig plug, or
touch the
green wire
to ground on hard-wired models.
If applicable, after the pattern has been set, tape or place a wirenut
over the end of the green wire to prevent it from coming into contact
with ground.
Pattern Programming
SYNCHRONIZATION
(Hard wire only)
You can synchronize up to six
lights with compatibility.
DO NOT CONNECT WHITE
WIRES UNTIL PROGRAMMING
HAS BEEN COMPLETED FOR
ALL LIGHTS!!
1. Program the first unit.
2. Program the second light with
the same
Pattern Type
.
Lights with the SAME phase
flash together (simultaneous).
Lights with DIFFERENT
phases flash opposite one
another (alternate).
3. After programming all lights,
cap off the green wires and
with the power off, connect
the white wires together.
4. Test lights by applying power
to all of them at the same
time.
Wiring Instructions
CAUTION:
All of our DC powered warning lights are
polarity sensitive. These lights are
polarity protected
only if the appropriate
fuse
is used. All wires connected to the
positive terminal of the battery should be
fused at the battery for their rated load.
Testing the light before this fuse is
properly installed will void the
warranty on the light.
RED:
Power - Connect to +12-24VDC through
your switch and a 5A fuse.
WHITE:
Synchronization - AFTER setting the flash
patterns, connect the white wires from
synchronized lights together. Cap off if not used.
GREEN:
Pattern Select - Touch & Release to ground.
BLACK:
Ground - Connect to the
negative terminal of the battery
or a good chassis ground.
Cig Plug Models : +12VDC only
Please Note: If your light contains a
PURPLE wire, it is a dead wire that is
not used and can be cut short.
†
- SAE J845 approved patterns when properly configured
Pattern Shortcuts: Hold Green wire to ground for
indicated time.
Steady Burn: Not in Pattern Cycle. Hold Green wire to
ground for 18 seconds (light will flash 5
times).
