-7-
(hardwired version only)
The
ULB9-1
(hard wire) should be wired through a 5 amp fuse (not supplied) and a 12VDC
switch (not supplied) capable of handling at least 5 amps. Connect the wires as follows:
Black
- Good Chassis Ground
Red
- Power (+12 VDC)
White
- Synchro:
AFTER PROGRAMMING
, Connect the white wires from the two lights
together to synchronize them together.
Green
- Pattern Select: Touch and release to Ground to scroll through the patterns.
The light will cycle back to the first pattern after pattern #24.
ULB9-1 and ULB9S-1 Wiring and Operation
FOR SYNCHRONIZATION BOTH LIGHTS MUST BE SET FOR THE SAME PATTERN TYPE!
Light 1
Light 2
(Programmed for same Phase)
Light 1
T
IM
E
(Programmed for opposite Phases)
Light 2
(Phase 1)
(Phase 2)
White Wires
(Phase 1)
(Phase 1)
White Wires
(OFF)
(ON)
White Wires
(OFF)
(ON)
(ON)
(ON)
White Wires
(OFF)
(OFF)
SYNCHRONIZATION
You can synchronize up to six lights
with compatibility.
DO NOT CONNECT WHITE WIRES
UNTIL PROGRAMMING HAS BEEN
COMPLETED FOR ALL LIGHTS!!
1. Power up the first unit and select
a Phase 1 pattern. Touch and
release the green wire to ground
to change patterns.
2. Program the second light
with the same
Pattern Type
.
Lights with the SAME phase
flash together
(simultaneous).
Lights with DIFFERENT
phases flash opposite one
another (alternate).
3. After programming all lights,
tie off the green wires and
connect the white wires
together.
4. Test lights by applying power
to all of them at the same time.
Phase 1
Flash
Pattern
Phase 2
Flash
Pattern
Pattern
Type
Pattern Description
Shortcut
1
13
K
Flicker
Pattern 1
(Phase 1)
:
3 sec or 1 flash
Pattern 13
(Phase 2)
:
9 sec or 3 flashes
2
14
L
Fast Doubleflash
3
15
M
Tripleflash
4
16
N
PSU Flicker
5
17
O
PSU Random
6
18
F
Quadflash
†
Pattern 6
(Phase 1)
:
6 Sec or 2 flash
Pattern 18
(Phase 2)
:
12 sec or 4 flashes
7
19
G
Quadflash w/Post-Pop
†
8
20
H
Singleflash
†
9
21
I
Doubleflash
†
10
22
J
Variable AKA Delta-Omega
11
23
C
Post Pop
12
24
E
Random
NA
Steady
18Sec
†
- SAE J595 and California Title 13 approved patterns
Pattern Shortcuts:
Hold Green wire to ground for indicated time.
Split Mode Phases:
One side flashes in Phase 1, the other
side flashes in Phase 2
Steady Burn:
Not in pattern cycle. Only accessible through
shortcut. Hold Green wire to ground for 18
seconds (light will flash 6 times).
FULL/SPLIT MODES
By default, the lights are programmed for the two halves of
the light alternate with one another (Split Mode). If you would
like to change this setting to Full Mode, proceed below:
•
Connect Black to Ground.
•
Connect Red and White to power.
•
Hold the green wire to Ground and release it when the
light flashes 4 times.(~12 seconds).
•
After an additional second, release the white wire.
This procedure will toggle the Full/Split mode.
