-4-
Pattern Select/Burst Mode Button
The button on the right half of the light is the
Pattern Select/Burst Mode
button. This is a
momentary switch and has four different functions, depending upon which mode the light is
in (i.e. which wire is activated).
Operation (CONT'D)
Please note that this button only functions properly if ONLY
the single wire indicated has +12VDC applied to it. If
multiple functions are activated, the Indicator LED (if
present) will flash four (4) quick times, indicating an error.
Warning LEDs in Flashing Mode (Only Orange w/Red wire activated):
If the
Star Phantom
®
is in Flashing Mode, the
Pattern Select/Burst Mode
button will
act as the Pattern Select button. Each time this switch-button is depressed,
The Star
Phantom
®
will cycle to the next pattern.
The Star Phantom
®
is designed with thirty-
five different patterns
(see next page)
.
DLP LEDs activated in Pursuit (flashing) Mode:
If
only
the
Red
and
White w/Brown
wires have +12VDC applied to them, the DLP
lights will be in Pursuit Mode (alternating back and forth). The
Pattern Select/Burst
Mode
button will allow you to select which speed you would like these lights to
alternate at 1.6FPS or 2.4FPS. Each time this switch-button is depressed and
released, the DLP lights will change speed.
Note: The indicator LED will momentarily
go off while the button is pressed in.
Warning LEDs in Steady Burn (Takedown) Mode (
Only Green w/Red wire activated
)
Or
DLP LEDs in Steady Burn (Takedown) Mode (
Only Green w/Yellow wire activated
):
If the
Star Phantom
®
DLP LEDs are in the Steady Burn Mode, the
Pattern Select/
Burst Mode
button will “burst” them into a super-bright, high-power mode (takedowns).
This mode will activate for approximately 30 seconds then revert to the standard steady
burn mode.
Please Note:
Immediately after the 30 second “Burst Mode” has ended, the
light will be “locked out” of Burst Mode for 30 seconds.
Pattern Select / Burst Mode
