Star Headlight & Lantern Contour S-Link System 9100DLED DUAL-COLOR MINIBAR, Руководство пользователя

Страница: 5 / 8

-4-
PATTERN PROGRAMMING
The Orange and Red wires can
each be programmed for its own
pattern.
1. Activate the wire that you
wish to program (Orange or
Red) by connecting it to
power (and the Black to
Ground).
2. Touch and release the
Pattern Select wire (Red w/
Green) to +12 VDC to scroll
through the patterns listed to
the right. The cycle repeats
after the last pattern.
Use the programming
shortcuts listed in the chart
below and to the right to
quickly jump to several
different patterns by holding
the Red w/Green Stripe Wire
to +12 VDC for the
corresponding length of time
for the pattern you would like
to jump to.
3. Once you find the pattern you
wish to display, tape off the
Red w/Green wire, and
deactivate the light. This will
store the selected pattern.
Hold Patt. Sel.
to +12VDC For
Unit Blinks Shortcut to
3 seconds 1 time Pattern 1
6 seconds 2 times Pattern 6
9 seconds 3 times Pattern 13
12 seconds 4 times Pattern 28
15 seconds 5 times Steady Burn
18 seconds 6 times
Toggles Dual
Color Mode
Programming
DUAL-COLOR MODE
The default setting is for the Orange and Red wires to each activate a different color. If
desired, you can program one wire to activate both colors. To do so, proceed as follows:
1. Activate the wire that is desired to be changed (Red or Orange) by connecting it to
+12VDC and connecting the Black wire to Ground.
2. Hold the Pattern Select wire (Red w/Green stripe) to +12VDC until the light flashes 6
times (~18 seconds), then release the wire. The activated wire should now be
displaying both colors.
3. Repeat process to turn off dual color mode.
STEADY BURN MODE
To program either of the wires for
Steady Burn Mode, activate that wire
and hold the Pattern Select wire (Red
w/Green) to power until the light
blinks 5 times (~15 seconds).