-2-
CAUTION:
All of our DC powered warning lights are polarity sensitive. These lights are
polarity protected
only if the appropriate fuse
is used. All wires connected to the positive
terminal of the battery should be fused at the battery for their rated load.
Testing the
light before this fuse is properly installed will void the warranty on the light.
Wiring for Permanent Mount Models
RED:
Power - Connect to +12-24VDC through your
switch and a 5A fuse.
GREEN:
Pattern Select - Touch & Release to ground.
BLACK:
Ground - Connect to the negative terminal
of the battery or a good chassis ground.
Cig Plug Models : +12VDC only
+12-24VDC
5A
FUSE
1. Power up the light and cycle through the flash patterns listed
below by pressing Pattern Select switch (
cig plug versions only),
or briefly touching and releasing the green wire to ground (
hard-
wired versions only
).
2. After the pattern has
been set, tape, or place
a wirenut over the end of
the green wire to prevent
it from coming into
contact with ground
again (hard-wired
versions).
3.
SHORTCUTS
:
Review the chart
below for a list of
how long you need
to touch the green
wire to ground or
hold the Pattern
Select button to
jump directly to a
desired pattern.
Pattern Programming
