Star Fans STAR X, Руководство пользователя, Страница: 8 / 9

1. TURN ON THE FAN
1
2. REVERSE FUNCTION BUTTON
Press any speed control button to turn on the fan and control the ceiling
fan speed from low to high. Button (I) is for the lowest speed, and button (VI)
is for the fastest speed.
Press this button to activate the reverse running function. The fan should run
in the forward direction for SUMMER setting and in reverse for WINTER setting.
3. LIGHT CONTROL BUTTON: (if the light kit installed)
Press to turn the light on and again to turn the light off.
By desault the light will come on when power to the fan is turned on.
4. TURN OFF THE FAN
Press this centre button to turn the fan off.
6.Remote Control Operation
2
3
4
Note: The auto learning function will only occur within 60 seconds of turning the fan’s
AC power ON.
1.Select desired frequency from the back of transmitter.
2.Press the transmitte r’s “off” button and hold the “o ff” button for over 10 seconds. Once the
receiver has detected the frequenc y, the down light of your fan if applicable will blink twice.
(There is no indication if your fan is not equipped with a light).
Note: The learning frequency function will continue to retain the last set frequency even when
the AC power is shut off.
The DC motor has a built in safety feature against obstruction during operation, if the fan motor
senses a obstruction for 60 seconds or more it will get locked and will not rotate until the
obstruction has been removed and the power has been disconnected for 5 seconds.
3.Over 60W protection: When the receiver detects motor power consumption which is greater
than 60W, the receive r’s power will stop and operation will be immediately discontinued, if you
want to re-start the fan, please remove obstacles and disconnect the power by turning off the
circuit breaker. And turn the power on after 5 seconds.
4.” DIM” and “ON/OFF” dip switch: The “DIM” selection is the light dimmable selection and
is to be used with all bulbs except for CFL bulbs.The” ON/OFF” selection is for CFL bulbs.
DIP Switches
DIP Switche configuration examples
Transmitter1 Transmitter2 Transmitter 3
DIP Switches
set to 00000
Battery
Battery cover
DIP Switches
set to 10000
DIP Switches
set to 11000
P6
ON
ON ON ON