8839615
V 1.4
Visit
for more information
13
Fig. 29
Fig. 30
UNPACKING AND ASSEMBLY
Step
Description
27.
Install the brake lights and rear turn indicators to the vehicle as shown in Fig. 30 (Red light on bottom)
by removing the two M6 self locking nuts shown in Fig. 29, inserting the studs through the holes on the
body, and tightening the M6 self locking nuts using an 8mm socket and socket wrench. Remove the
plastic protective film on both the turn and brake indicators. Plug the lights into their respective plugs
and use the included plastic wire ties to secure the wires against the frame and to keep them from
hanging down (Fig 31). Repeat this step for the opposite side brake and turning indicator.
BATTERY INSTALLATION AND CHARGING
Face Shield
Goggles
Rubber Gloves
Vinyl Apron
REQUIRED PERSONAL PROTECTIVE EQUIPMENT
WARNING!
The following procedure is
VERY DANGEROUS
and should be performed with the utmost care and
attention. Always wear protective personal equipment including eye wear, face shield, apron, and rubber gloves.
Have a running water source available should electrolyte come in contact with skin or eyes.
KEEP ALL CHILDREN AWAY FROM THE AREA WHILE THIS PROCEDURE IS BEING PERFORMED.
Fig. 31
