8) TARGET LIGHT BASE
Insert target light to the deck and it will light up.
9) KEY LOCK
Press to enable Key Lock. When Key Lock is on, the pitch slider will only affect the speed of the platter. The key
(tone) will remain at 0%.
Note: Key Lock processing is only available when the LINE output is used.
10) PITCH LOCK
The ON setting will allow use of the pitch adjust. When set of OFF, the pitch control will be locked at 0%.
11) PITCH SLIDER
The pitch slider is used to speed up or slow down the turntable platter.
12) HEADSHELL LOCKING NUT
Attach the headshell by inserting into the front end of the tone arm. Turn the locking nut clockwise with the head
shell firmly held horizontally.
13) TONE ARM
This is a fully manual tone arm. To start playback, gently place the stylus on the record using the headshell finger
support. Do not drop the stylus onto the record as it may cause damage to the diamond tip and to the record.
14) PITCH SELECT
Press the button to select b/-8% and +/-12% pitch range.
15) TONE ARM BASE
The tone arm base includes tone arm rest.
16) COUNTERWEIGHT
Use this to balance the tone arm and to adjust the stylus pressure. See “tone arm and cartridge settings” for
proper adjustments.
17) 45-RPM ADAPTOR HOLDER
Place on the attached 45-rpm adaptor here. Push down the rear side of 45 rpm adaptor to take it.
18) EXTRA STYLUS HOLDER
Place extra headshells here.
19) PHONO/LINE OUTPUT L & R
This is the standard analog output (RCA jacks) which can be connected either to a phono or line input on any DJ
mixer, depending on the setting of the phono / line selector.
Note: Key Lock processing is only available when the LINE output is used.
PART NAMES & FUNCTIONS
19 20 21
22 23
