39.
ELAPSED / TOTAL / REMAIN
– Indicates whether the time shown on the display refers to total remaining time or track remaining time. If
either of these are not illuminated, this indicates elapsed track time.
40.
RELOOP
– Indicates when there is a previously set loop, and that the loop is ready to be played again.
41.
LOOP
– Indicates when the CD is in loop mode.
42.
SINGLE
– Controlled by the SGL/CTN button, this indicates when the unit is set to play just one track at a time. When this is not illuminated,
the CD will play continuously through all tracks.
A)
CHECKING THE CONTENTS – Check that the carton contains all of the following items.
• Tabletop CD player unit
• User’s manual
• One pair RCA cable
• One power cable
• One fader start / relay cable
B)
INSTALLING THE UNIT
• Place the unit on a flat, level surface.
• Be sure the player is in a well-ventilated area where it will not be exposed to direct sunlight, high
temperatures, or high humidity.
• Try to place the unit as far as possible from Tvs and tuners, as the unit may cause undesirable interference.
• The player will work normally when the unit is within 15 degrees of the vertical plane. If the unit is tilted
excessively, discs may not load or unload properly, or playback may be adversely affected.
• The unit’s LCD screen is designed to be clearly visible within the angles shown in the figure below. Place the
unit so that the LCD screen is within this visual range for optimal clarity.
C)
CONNECTIONS
• Make sure that the unit and any other equipment in the signal chain are turned off prior to making
any connections.
• Connect the RCA cable to the rear of the unit and to the input on your mixer.
• Connect the power cable to the rear of the unit and to a proper AC outlet.
D)
CAUTION
• Be sure to use the supplied cables. Using other types of cables may result in unit damage.
• To avoid severe damage to the unit, be sure the power is OFF when making any connections.
SET-UP
