Stanley STGS8100, Руководство пользователя, Страница: 9 / 20

ENGLISH
8
are rotating in the direction of the arrows on the
accessories and tool.
Operation (Fig. 5)
Instructions
WARNING: Always observe the safety
instructions and applicable regulations.
WARNING: To minimize the danger
of serious personal injury, please
switch off the tool power and
disconnect all plugs before adjusting
or removing/installing any accessory.
Before reassembling the tool, press and
release the trigger switch to make sure
the tool is already switched off.
WARNING:
• Make sure all materials to be grinded
are secured in position.
• Apply slight pressure to the tool. Do
not apply side pressure to the abrasive
disc.
• Avoid overloading. If the tool becomes
hot, let it spin for a few minutes with no
load.
1. Be sure to hold the tool tightly with both hands
(one hand on housing, the other on side
handle). Start the tool and bring the grinding
wheel on the workpiece.
2. Keep the edge of the wheel tilted at angle from
15 to 30 degrees against the surface of the
workpiece.
3. When using a new grinding wheel, do not
operate the wheel in the B direction, otherwise,
it will cut into the workpiece. When the edge
of wheel has been rounded off, you are free to
operate the grinder in either the A or B direction.
Starting and Stopping (Fig. 1)
WARNING: Before using the tool, check
whether the handle is tightened securely.
Check whether the ON/OFF switch is
working normally.
Slider switch (STGS8100)
Before plugging in the tool to the power supply,
check whether the switch is in the OFF (a) position
when pressing the rear end of the switch.
To start the tool, press the rear end of the switch
and slide it forward. Then press the front end of the
switch to lock it. Press the rear end of the switch to
stop the tool.
Toggle swithch (STGT8100)
To run the tool, press the switch (o) in before moving
it completely forward.
To stop the tool, move the switch (o) back the
opposite way.
to stop the tool in continuous operation, press on
back part of the switch.
WARNING: Do not switch the
tool on or off while under load
conditions.
Proper Hand Position (Fig. 6)
WARNING: To reduce the risk of serious
personal injury, ALWAYS use proper
hand position as shown.
WARNING: To reduce the risk of serious
personal injury, ALWAYS hold securely in
anticipation of a sudden reaction.
Proper hand position requires one hand on the side
handle (figure 1), with the other hand on the body of
the tool, as shown in figure 6.
Switches
CAUTION: Hold the body of the tool
firmly to maintain control of the tool at
start up and during use and until the
wheel or accessory stops rotating. Make
sure the wheel has come to a complete
stop be fore laying the tool down.
NOTE: To reduce unexpected tool movement, do not
switch the tool on or off while under load conditions.
Allow the grinder to run up to full speed before
touching the work surface. Lift the tool from the
surface before turning the tool off. Allow the tool to
stop rotating before putting it down.
SLIDER SWITCH (Fig. 1)
WARNING: Before connecting the tool
to a power supply, be sure the slider
switch is in the off position by pressing
the rear part of the switch and releasing.
Ensure the slider switch is in the off
position as described above after any
interruption in power supply to the tool,
such as the activation of a ground fault
interrupter, throwing of a circuit breaker,
accidental unplugging, or power failure.