Stanley STEL811, Руководство пользователя

Страница: 7 / 36

7
ENGLISH
Mounting the Side Handle (Fig. F)
Screw the side handle (2) tightly into one of the three holes (18) on
the gear case.
Instruction for Use

Always observe the safety instructions and applicable
regulations.

Ensure all materials to be ground are secured in palce.

Apply only a gentle pressure to the tool. Do not exert side
pressure on the grinding wheel or cutting disc.

Avoid overloading. Should the tool become hot, let it run a
few minutes under no load condition.

Slide after push
Prior to Operation

Install the appropriate guard and disc or wheel. Do not
use excessively worn discs or wheels.

Be sure the inner and threaded flanges are mounted
correctly.

Make sure the disc or wheel rotates in the direction of the
arrows on the accessory and the tool.
Switching On And Off (Fig. A)
@ Make sure that the switch is in the "OFF” position
before plugging in.

To run the tool, slide the ON/OFF switch (1) forward to the
“ON” position.

To stop the tool, slide the switch backwards to the "OFF”
position.

Always switch off the tool when work is finished and before
unplugging.
@
Do not switch the tool ON and OFF when under load.
Handy Hints (Fig. G)

Hold your angle grinder with one hand on the body and the
other hand firmly around the side handle.

Always position the guard so that as much of the exposed
disc as possible is pointing away from you.

Be prepared for a stream of sparks when the disc touches
the metal.
Grinding (Fig. H)
Use a depressed center Type 27 disc. Hold the tool at an
angle of approximately 20º-30º to work for grinding.
Edge Grinding and Cutting
@
Do not use edge grinding wheels for surface
grinding applications because these wheels are
notdesigned for side pressures encountered with
surface grinding. Wheel breakage and injury may
result.
Maintenance
Your Stanley power tool has been designed to operate
over a long period of time with a minimum of maintenance.
Continuous satisfactory operation depends upon proper tool
care and regular cleaning.Your tool is not user-serviceable.
Take the tool to an authorized Stanley repair agent.
This tool should beserviced at regular intervals or when
showing a noticeable change in performance.
Lubrication
Stanley power tools are properly lubricated at the factory
and are ready for use. Tools should be relubricatedregularly ,
depending on usage. This lubrication should only be
attempted by trained power tool repair persons, such as
those at Stanley service centers or by other qualified service
personnel.
Edge grinding can be performed with type 27
wheels designed and specificed for this purpose.
Protect yourself during edge grinding by directing
the open side of the guard toward a surface. Edge
grinding wheels should contact the work surface
only at the edge of the wheel, not on the top or
bottom of the wheel.Side pressure on the wheel
could lead to breakage of the wheel.
Cleaning
@
Warning: unplug the tool before you use a cloth to
clean the housing.With the motor running, blow dirt
and dust out of all air vents with dry air at least once
a week. Wear safety glasses when performing this.
Exterior plastic parts may be cleaned with a damp
cloth and mild detergent. Although these parts are
highly solvent resistant, NEVER use solvents.
Tool Care
Avoid overloading the machine.Overloading will result in a
considerable reduction in speed and efficiency and the unit
will become hot. In this event,run the machine at no load for
a minute or two until cooled to normal working temperature
by the built in fan. Switching your machine on and off whilst
under load will considerably reduce the life of the switch.