Stanley STEL705, Быстрый старт

Страница: 8 / 16

8
ENGLISH
3. Reduce cutting force, let the wheel do the work.
4. Clamp work piece securely. See
Material Clamping and
Supporting, page
6. Make sure material is laying flat against the base.
Trouble!
Material moves during cut.
What’s Wrong?
1. Fence slipping or workpiece incorrectly placed or
clamped.
2. Vise too loose
3. Excessive cutting force.
What to do…
1. See
Material Clamping and Supporting, page 6.
2. Tighten vise clamping.
3. Reduce cutting force.
TROUBLE SHOOTING GUIDE
Trouble!
Tool will not start.
What’s Wrong?
1. Tool not plugged in.
2. Fuse blown or circuit breaker tripped.
3. Cord damaged.
4. Brushes worn out.
What to do…
1. Plug in saw.
2. Replace fuse or reset circuit breaker.
3. Have cord replaced by authorized service center.
4. Replace brushes.
Trouble!
Tool makes unsatisfactory cuts.
What’s Wrong?
1. Glazed wheel.
2. Workpiece incorrectly placed or clamped.
What to do…
1. Dress the wheel or replace with a new one.
2. Firmly clamp and support workpiece.
Trouble!
Blade does not come up to speed.
What’s Wrong?
1. Extension cord too light or too long.
2. Low voltage.
3. Low generator voltage.
What to do…
1. Replace with adequate size cord. See chart on page1.
2. Contact your electric company.
3. Check generator output voltage. Reduce number of
tools powered by the generator.
Trouble!
Tool vibrates excessively during cut.
What’s Wrong?
1. Damaged wheel.
2. Workpiece not clamped properly.
What to do…
1. Replace wheel.
2. Refer to
Material Clamping and Supporting page 6.
Trouble!
Does not make accurate cuts.
What’s Wrong?
1. Fence not adjusted correctly.
2. Wheel is not square to fence.
3. Excessive force used to make cut.4.Work piece
moving.
What to do…
1. Check and adjust. See
Fence Operationon page 6.
2. Check and adjust.