Stanley STDH7213C, Оригинальное руководство пользователя, Страница: 7 / 22

• Check for damage to the tool, parts or accessories which
may have occurred during transport.
• Take the time to thoroughly read and understand this
manual prior to operation.
Description (fig. A)
1. Variable speed switch
2. Lock-on button
3. Forward/reverse slider
4. Mode selector
5. Ventilation slots
6. Side handle
7. Depth adjustment rod
8. Keyless chuck
9. Sleeve
10. Speed dail
Assembly
Warning! Before assembly, please ensure that the power
tool is powered off and the power plug of the tool is
unplugged from the power source.
Selecting the operating mode (fig. B) The tool can be used in
two operating modes:
Rotary drilling:
for steel, wood and plastics.
Impact drilling:
simultaneous rotating and impacting for concrete and
masonry drilling operations.
• Select the required operating mode by rotating the mode
selector (4) to the required position.
Inserting and removing a bit (fig. A,D)
Keyless chuck
The STDH7213 features a keyless chuck (d) for greater
convenience.
To Insert A Drill Bit Or Other Accessory.
• Grasp the rear half of the chuck with one handand use
your other hand to rotate the front half counterclockwise,
as shown in Figure 6. Rotate far enough so that the
chuck opens sufficiently to accept the desired accessory.
• Insert the bit or other accessory about 19 mm (3/4") into
the chuck and tighten securely by holding the rear half of
the chuck and rotating the front portion in the clockwise
direction. When the chuck is nearly tightened, you will
hear a clicking sound. After 4–6 clicks, the chuck is
securely tightened around the accessory.
• To release the accessory, repeat step 1 listed above.
Warning! Do not attempt to tighten drill bits (or any other
accessory) by gripping the front part of the chuck and
turning the tool on. Damage to the chuck and personal injury
may result.
Keyless Chuck Removal (Fig. D)
Tighten the chuck around the shorter end of a hex key (not
supplied). Using a soft hammer or piece of wood, strike the
longer end in the counterclockwise direction. This will loosen
the chuck so that it can be unscrewed by hand.
Keyless Chuck Installation (Fig. D)
Screw the chuck on by hand as far as it will go. Tighten the
chuck around the shorter end of a hex key (not supplied)
and strike the longer end in the clockwise direction with a
soft hammer.
Fitting the side handle (fig. A)
The side handle (6) can be fitted to suit both RH- and
LH-users.
Always use the drill with the side handle properly
assembled.
• Loosen the side handle.
• For RH-users, slide the side handle clamp overthe collar
behind the chuck, handle at the left.
• For LH-users, slide the side handle clamp colar behind
the chuck, handle at the right.
• Rotate the side handle to the desired positionand tighten
the handle.
Setting the drilling depth (fig. C)
• Insert the required drill bit into the chuck.
• Slacken the side handle (6).
• Fit the depth adjustment rod (7) through the hole in the
side handle clamp.
• Adjust the drilling depth as shown.
• Tighten the side handle.
Forward/reverse slider (fig. A)
• To select forward or reverse rotation, use the
forward/reverse-switch (3) (see arrow on tool).
Always wait until the motor has come to a
complete standstill before changing the direction of
rotation.
7
ENGLISH
(Original instructions)