Stanley SGS104, Оригинальная инструкция, Страница: 8 / 20

ENGLISH (
Original Instructions)
8
– Risk of dust from hazardous substances.
Tool Symbols
The following symbols are printed on the tool:
Read the instruction manual before use.
Please wear hearing protectors.
Please wear eye protection equipment.
POSITION OF DATE BARCODE (FIG. 1)
The date barcode (n), including the year of manufacturing, is
printed on the tool housing.
E.g.:
2017 XX JN
Year of manufacturin
PACKAGE CONTENT
This product package includes:
1 Angle grinder
1 Guard
1 Flange set
1 Spanner
1 Handle (only apply for SGS104, SGS1045, SGS105)
1 Instruction manual
• Check the tool, parts, and accessories to see if they are
damaged during transportation.
• Take a few moments to read and understand this manual
before using the tool.
Description (Fig. 1)
Warning: Never modify the power tool
or any part of the tool, otherwise it may
cause damage to the tool or result in
personal injury.
a. ON/OFF switch
b. Spindle lock
c. Guard
PURPOSE OF DESIGN
This angle grinder is designed especially for grinding.
Do not
use sandpaper discs and grinding wheels other than
those with depressed center.
Do not
use the tool in wet conditions or environments in the
presence of flammable liquids or gases.
This heavy-duty angle grinder is a professional power tool.
Do not
allow children to come in contact with this tool.
Inexperienced operators are required to use this tool under
supervision.
ELECTRICAL EQUIPMENT SAFETY
Only one voltage is applicable to this tool. Be sure to check that
the power suuply corresponds to the voltage on the rating plate
.
Your Stanley tool is equipped with double
insulation, hence, it does not require to be
earthed.
When the power cord is damaged, have it sent to a
Stanley service center for replacement to specially
prepared cables.
USING EXTENSION CORDS
If an extension cord is required, please select a 3-phase
extension cord that has been inspected and matches the
input power (see Technical Data) of this tool. The minimum
conductor size is 1.5mm2, maximum length is 30 meters.
When using a cable reel, be sure to pull out all the cables.
ASSEMBLY AND ADJUSTMENT
WARNING:
To minimize the danger of serious
personal injury, please switch
off the t
ool
power and disconnect all plugs before adjusting
or removing/installing any accessory. Before
reassembling the tool, press and release the trigger
switch to make sure the tool is already switched
off.
Attaching and Removing the Wheel Guard (Fig. 2)
WARNING:
To minimize the danger of
serious personal injury, please switch off the tool
power and disconnect all plugs before adjusting
or removing/installing any accessory. Before
reassembling the tool, press and release the trigger
switch to make sure the tool is already switched
off.
Attaching the Guard
1. Place the angle grinder on a work bench, groove facing
up.
2. Bring the flange of the guard (c) collar over the groove (i)
of the gear housing.
3. Turn the guard (c) counterclockwise by 150 degrees.
4. Make sure that the screws (k) are tightened.
Removing the Guard
1. Loosen the screws (k) on the guard collar.
2. Pull up the guard (c).