7 of 18
®
BEAST Electric Pressure Washers
Rev: Jan 2018
PREPARATION & ASSEMBLY - Model P1450B, P1450B-CAN, P1500B, P1600B, P1600B-BB, P1600B-CAN,
P1760B-BB
Assembly Time: 5 minutes
Tools Required: 17mm or Adjustable Wrench
Note: 17mm wrench (Part L pg. 3) is provided in hardware bag.
Surface Preparation
Before starting any cleaning task, it is important to inspect the area
for objects which could create a hazard.
Remove any objects from the work area which could be tripped
over, such as toys or outdoor furniture.
Step 1
Remove or peel off blue protective film on the front of the pressure
washer and on the wands (if applicable). Also, remove any bubble
wrap. Discard blue protective film and bubble wrap.
Step 2
Attach the Zinc Connect or Quick Connect Inlet coupling to water
supply inlet on pressure washer, as shown in Figure below.
On some models the coupling or quick connect may be installed at
the factory for your convenience.
Step 3
Attach Wand Bracket to the unit as shown in Figure below.
Step 4
Attach High Pressure Hose to Main Unit as shown in Figure below.
Step 5
Attach other end of High Pressure Hose to Gun as shown in Figure
below. Fasten tightly with 17mm wrench to avoid leakage.
Step 7
Attach the hose holder strap to the side of the unit as shown in
Figure below.
Step 6
Attach Tool Belt to the Strap Bracket as shown in Figure below.
The belt bracket is secured by two provided screws to the machine
body.
The bracket is installed at the factory on most models.
For Operating Instructions, proceed to page 9.
