6
7
1. Use one hand to hold the head lamp body and use the thumb on the other
hand to push down the back cover release button while lightly applying force
on the fastening buckle to gently pull out the back cover.
2. Insert the batteries correctly according to the symbols shown inside the
battery compartment.
3. Replace the back cover by aligning it to the back cover release button.
4. Then snap the back cover into the head lamp body through the bottom lock.
Replacing the batteries
1.
2.
3.
4.
WARNINGS:
Refer to the safety warnings in the front of this instruction
manual when selecting and replacing batteries. Always dispose of used batteries
properly.
OPERATING THE HEAD LAMP
Adjust the strap to fit head size. Place the head lamp on your head and turn the
unit on by sliding the power slide switch either to the left for solid light or to
the right for flashing light. When not in use, turn the unit off by sliding back the
power slide switch to center position.
CARE AND MAINTENANCE
If the unit gets dirty, gently clean the outer surfaces of the headlamp with a soft
cloth moistened with a mild solution of water and detergent.
•
Keep batteries out of reach of children.
•
Remove batteries if the device will not be used for several months.
“Transporting batteries can possibly cause fires if the battery terminals
inadvertently come in contact with conductive materials such as keys, coins,
hand tools and the like. The US Department of Transportation Hazardous Material
Regulations (HMR) actually prohibit transporting batteries in commerce or on
airplanes (i.e. packed in suitcases and carryon luggage) UNLESS they are properly
protected from short circuits. So when transporting individual batteries, make sure
that the battery terminals are protected and well insulated from materials that
could contact them and cause a short circuit.”
SAVE THESE INSTRUCTIONS
INTRODUCTION
Congratulations on purchasing your new Stanley Headlamp.
Read this
Instruction Manual and follow the instructions carefully before
using your new headlamp.
POWER SUPPLY
The unit is powered by three “AAA” alkaline dry cell batteries (may be sold
separately) inside the battery compartment.
Head lamp battery replacement/disposal
The head lamp is powered by three AAA alkaline batteries (may be sold
separately). The battery compartment is located on the back of the head lamp.
Refer to the illustrations below and the steps that follow to replace the batteries:
HL2PKS_ManualENSP_072412.indd 6-7
7/24/2012 11:08:04 AM
