16 GT23 User Manual
1
Unit not calibrated
yes
Have engine serviced by an Authorized Stanley Dealer.
2
Engine speed excessive
yes
Have engine serviced by an Authorized Stanley Dealer.
3
Engine speed unusually low
yes
Have engine serviced by an Authorized Stanley Dealer.
4
Engine shutdown due to engine
yes
Have engine serviced by an Authorized Stanley Dealer.
protection
input
5
Factory settings lost
yes
Have engine serviced by an Authorized Stanley Dealer.
6
External pot out-of-range
no
Have engine serviced by an Authorized Stanley Dealer.
7
Accelerator position / idle
no
Have engine serviced by an Authorized Stanley Dealer.
switch conflict
8
Controller unit failed
yes
Have engine serviced by an Authorized Stanley Dealer.
9
Limiting excessive
no
Have engine serviced by an Authorized Stanley Dealer.
actuator
current
10
Engine speed input
no
(Active only in Auto crank mode).
signal missing
Check speed sensor wiring.
Check starter motor.
11
Auto crank unable to
no
Check fuel.
start
engine
12
Auxiliary output is shorted
no
Check the lamp or relay hooked to the output. If fault is
still present, have engine serviced by an authorized
Stanley
Dealer.
13
Auxiliary output #2 is shorted
no
Check the lamp or relay hooked to the output. If fault is
still present, have engine serviced by an authorized
Stanley
dealer.
14
Actuator disconnected or
no
Check actuator wiring and actuator resistance.
open circuit
Resistance should be less than 10 ohms.
FLASH ENGINE
CODE
FAULT
SHUTDOWN
CORRECTIVE ACTION
FAULT CODES
