Stanley FATMAX TLM 100, Руководство пользователя

Страница: 4 / 102

Battery Safety
WARNING:
Batteries can explode, or leak, and
can cause injury or fire. To reduce
this risk:
• Carefully follow all instructions and warnings on
the battery label and package.
• Always insert batteries correctly with regard to
polarity (+ and –), as marked on the battery and
the equipment.
• Do not short battery terminals.
• Do not charge disposable batteries.
• Do not mix old and new batteries. Replace all
batteries at the same time with new batteries of
the same brand and type.
• Remove dead batteries immediately and
dispose of per local codes.
• Do not dispose of batteries in fire.
Keep batteries out of reach of children.
Installing AAA Batteries
1. Locate the battery compartment latch on the
back of the tool (Figure
B 2
).
2. Using your finger, pull the latch down to
unlock and remove the battery door (Figure
C 1
).
3. Insert two AAA batteries, making sure to
position the - and + ends of each battery as
noted inside the battery compartment (Figure
C 2
).
4. Slide the pins at the bottom of the battery door
into the notches in the battery compartment
(Figure
C 3
), and push the door down until it
snaps into place.
When the tool is ON, the battery level appears in
the display window (Figure
E 1
).
Using the TLM50/100
1.
Point the laser at the top of the tool (Figure
A 1
) toward the wall whose distance you
need to measure (Figure
D 1
).
2. Click (Figure
A 3
) to display a laser dot
on the wall (Figure
D 1
) and measure the
distance from the bottom of the tool to the wall
(Figure
D 2
).
3.
At the bottom of the display window (Figure
A 2
), view the current measurement (Figure
E 3
), which will keep changing as you move
the tool (in Continuous Measure mode).
4. When the bottom of the tool is positioned at
the correct distance from the wall, click to
take the current measurement on the display
window (Figure
E 3
).
Changing the Unit of Measure
Once the current measurement is taken, you
can change the unit of measure from decimal ft
(6.21 ft) to fractional ft (6'02"9/16), fractional ft to
meters (1.894 m), meters to inches (74 9/16 in),
or inches to decimal ft.
To change the unit of measurement, press and
hold until you see the measurement change
(3 seconds).
NOTE: If you continue to hold
after the
measurement changes, the tool will turn off.
Re-measuring
If you need to take a new measurement, click .
• The previous measurement (Figure
E 2
) will
appear above the new current measurement
(Figure
E 3
).
• When you are ready to take the new current
measurement, click .
4
GB